Skip to content

Careful builds and clear updates. Consultations at (864) 635-4785

Mauldin · Greenville · Simpsonville · Five Forks

(864) 635-4785
Installer kneeling on a bare subfloor, tapping a wide oak-look plank into place with a mallet in an empty living room with a kitchen and windows behind

ServicesFlooring Installation

Flooring Installation in Mauldin

A new floor is only as good as what sits under it. We check and correct the subfloor, let the material acclimate, and install hardwood, tile or luxury vinyl with tight seams and clean transitions. We keep the rest of your home covered and tell you each day what comes next.

Floors that start with the subfloor

Most flooring problems trace back to the layer you never see. A subfloor that dips, squeaks or holds moisture will telegraph through vinyl, crack grout lines and open gaps between hardwood boards. So we start there, with a straightedge and a moisture meter, before anything new goes down.

We install flooring in new custom homes we build and in existing homes as part of a remodel or a room-by-room update. The craftsmanship is the same either way: careful layout so boards and tiles land evenly at doorways, trim that is scribed to the wall, and transitions that sit flush rather than becoming a trip edge.

Living in the house while we work is normal. We seal off the rooms we are in, run plastic over doorways and lay runners along the paths we use, so the floors and furniture you are keeping stay as they were.

What our flooring work includes

Removal of the old floor

We pull carpet, pad, tack strip, old vinyl or tile and haul it away. Staples and adhesive ridges come up too, so nothing lumpy is left under the new layer.

Subfloor checks and repair

We look for soft plywood, squeaks, high seams and low spots. Loose panels get screwed down, damaged sections get replaced, and dips are filled or high spots sanded so the floor meets the flatness the manufacturer calls for.

Moisture testing and acclimation

Wood moves with humidity, and Upstate summers are humid. We test the subfloor and let hardwood sit in the conditioned house before installing, which helps prevent cupping and gaps later.

Installation by material

Nail-down or glued hardwood, floating or glue-down luxury vinyl plank, and tile set on a proper underlayment or backer board. Each gets the method its manufacturer specifies.

Trim, transitions and thresholds

Baseboard and shoe molding are reset or replaced, door casings are undercut so the new floor slips beneath them, and thresholds are matched to the height change between rooms.

Daily cleanup

We vacuum and sweep at the end of each day, and leave the finished floor clean enough to move furniture back onto.

Builder in a cap and work vest points at a framed wall while a couple looks on inside a wood-framed house, with a brick ranch home visible through an opening

Signs your floors are ready for replacement

Soft or springy spots
A floor that gives underfoot usually means the subfloor has taken on water or the fasteners have worked loose. That has to be dealt with before any new surface goes down.
Gaps and cupped boards
Hardwood with wide seasonal gaps or edges that curl upward is often reacting to moisture. Replacing it without finding the source only repeats the problem.
Cracked tile and loose grout
Cracks that run across several tiles point to movement underneath, not one bad tile. A new installation over a stiffened subfloor addresses the cause.
No surface left to sand
Some engineered boards carry only a thin top veneer, and laminate has a printed pattern that wears off. Once those are worn through, sanding is not an option, and a new floor is the honest recommendation.
Mismatched floors through the house
Three or four flooring types meeting at doorways makes a home feel chopped up. Running one material through connected rooms often changes how the whole floor plan feels.

How a flooring project runs

  1. 1

    Project consultation

    We talk through the rooms, how you use them, and the materials you are weighing. Then we measure, check the subfloor and give you a written estimate with each part of the work listed.

  2. 2

    Material delivery and prep

    Flooring arrives and acclimates in the house. We cover the floors and furniture that stay, seal doorways with plastic and agree on which entrance we will use.

  3. 3

    Tear-out and subfloor work

    Old flooring comes out and the subfloor is repaired and flattened. If we find hidden damage, we show you photos and explain the options before doing anything beyond the estimate.

  4. 4

    Installation and trim

    We lay out from the room's most visible line, install the floor, then set transitions and trim. You get a short update at the end of each day.

  5. 5

    Walkthrough

    We walk the finished floor with you, remove protection, clean up and go over care instructions for the material you chose.

What moves the cost of new flooring

Flooring price depends far more on the house than on the square footage alone. We list each item separately in your estimate so you can see where the money goes. If something unexpected turns up under the old floor, you hear about it before the work changes.

Material choice
Solid hardwood, engineered wood, luxury vinyl and tile vary widely in material cost and in how much labor each takes to install.
Subfloor condition
A flat, dry subfloor keeps the job simple. Water damage, rot or significant leveling adds time and material.
Removal of existing flooring
Carpet lifts quickly. Glued-down vinyl or tile set on a mortar bed takes much longer to remove cleanly.
Layout and room shape
Stairs, closets, angled walls and patterns like herringbone or diagonal tile add cuts and waste.
Trim and transitions
Reusing existing baseboard costs less than new trim, and the number of doorways and height changes affects thresholds.

Flooring installation questions

Can we stay in the house while you install flooring?
Yes, most families do. We work one section of the house at a time, seal off the rooms we are in and keep a clear path to the kitchen and bedrooms. We tell you ahead of time which rooms will be out of use and for how long.
Which flooring holds up best in a humid climate?
Engineered hardwood and luxury vinyl plank both handle humidity swings better than solid hardwood. Tile is the most stable of all. Solid hardwood works well too, as long as the subfloor is dry, the house is conditioned and the wood is given time to acclimate first.
Can you put new flooring over the old floor?
Sometimes. Luxury vinyl can go over flat tile or sheet vinyl that is still firmly stuck down, which saves tear-out. Floor height at doors and cabinets matters, though, and anything loose or soft has to come up. We check and give you a straight answer during the consultation.
What stands behind the work once it is finished?
We are licensed in South Carolina and in North Carolina. Our flooring installation comes with a 1-year warranty on workmanship, so if a seam lifts or a board loosens because of how it was put down, we come back and make it right.
Do you install flooring as part of a larger remodel?
Yes. Flooring usually goes in near the end of a home remodeling project, after walls, cabinets and paint, so other trades are not working over the new surface. We schedule it that way when we handle the whole job.
Remodeled bathroom with a sage green double vanity, marble countertop, large mirror, glass walk-in tile shower and large gray tile floor

Talk through your floors with us

Tell us about the rooms and the material you have in mind. We will come out, check the subfloor and walk you through the options in a project consultation.